Turn steering wheel against the right steering lock
and hold.
Confirm with RETURN.
Fig. 7
Release hand brake and drive the tractor forwards
slowly, keeping the wheels straight.
NOTE:
This calibration is an important requirement for
ensuring correct way-line guidance.
Confirm with RETURN.
Fig. 8
If calibration is completed without errors, O.K.
appears and the new sensor settings are saved.
NOTE:
Settings are only stored when ignition key has
been turned to "0" position.
Wait for at least 30 seconds before switching on
ignition again!
Fig. 9
If incorrect values are detected or the conditions
are not met, the message ERROR appears.
2401 = calibration code
FXX = fault code
Fig. 10
6. VarioGuide components and calibrations
VarioGuide 57
438.020.070.012
To Next Page
Loading...
Need help?
General