Fax Procedure
43
Basic Operations
3
Fax Procedure
This section describes the basic fax procedures. The following shows the reference section
for each procedure.
Step 1 Loading Documents.......................................................................................................................................................... 43
Step 2 Selecting Features............................................................................................................................................................. 43
Step 3 Specifying Destinations ................................................................................................................................................... 44
Step 4 Starting the Fax Job.......................................................................................................................................................... 45
Step 5 Confirming the Fax Job in Job Status........................................................................................................................... 46
Stopping the Fax Job..................................................................................................................................................................... 46
Step 1 Loading Documents
1
Load the document face up (when the
document is 2-sided, load the front side up) in
the center of the document feeder, or load the
document face down and align it against the
top left corner of the document glass.
For more information on how to load the document, refer to
"Step 1 Loading Documents" (P.36).
Step 2 Selecting Features
The following two services are available to send faxes.
Simple Fax
Allows you to only select basic features to send faxes.
Fax/Internet Fax
Allows you to make detailed settings to send faxes.
The following procedure uses [Fax/Internet Fax] to describe how to select features.
Note •The features to be displayed on the screen depend on your machine configuration.
• When the Authentication or Accounting feature is enabled, a user ID and passcode may be required.
Ask your system administrator for the user ID and passcode.
1 Press the <Services Home> button.
123
456
789
0
#
C
スタート
ジョブ確認
設定確認
(未登録)
メニュー
コピー
認証
デ
クリア
ポーズ
短縮
リセット
主電源
割り込み