To Next Page

To Previous Page

15 Appendix

536

Appendix

Paper Margin

The paper size is set to A series paper by factory default. If the print data is larger than the

active coordinates area, the machine prints the data on the next larger A series paper.

When you set the paper margins, however, the active coordinates area is determined by

subtracting the area set in paper margins from the active coordinates area obtained in the

area determination mode. Therefore, set the paper margins if the data is printed on larger

paper than specified. Set the range from 0 to 99 mm. The default value is 0 mm.

HP-GL/2 Emulation Settings

The following table shows the emulation parameters and their values for HP-GL/2

emulation.

HP-GL/2 Settings List

Items that can be set using the HP-GL/2 mode menu are explained in two groups: basic

settings and extended settings.

Basic Settings

Parameter Item No. Value

Document size 101 Sets the document size created by a computer.

[0] : A0

[1] : A1

[2] : A2

[3] : A3

[4] : A4

[5] : A5

[10] : B0

[11] : B1

[12] : B2

[13] : B3

[14] : B4

[15] : B5

[99] (Default) : Auto

[100] : Paper

When [Auto] is selected, the settings of the Scaling mode, the Area

Determination mode, and the Paper Margin settings of Print Control become

enabled.

Note • If the document size other than [Auto] is selected, the settings under [Auto

layout] become [ON].

• Depending on the combination of [Document size] and [Paper size], the

document is printed at a scale of 100%.

Fuji Xerox DocuPrint M465 AP Administrator's Guide

Other manuals for Fuji Xerox DocuPrint M465 AP