Fujitsu ScanSnap S1300 User Manual

How to Perform a Scan (for Mac OS users)
172
How to Perform a Scan
This section explains how to perform a scan with the ScanSnap.
■ Preparation
1. Make sure that the power cable is connected to the ScanSnap properly.
2. Make sure that the ScanSnap is connected to your computer properly.
3. Turn on the computer.
D The ScanSnap Manager icon appears in the Dock when Mac OS is started up.
4. Open the ADF paper chute (cover) of the ScanSnap.
D The ScanSnap is turned on and the ScanSnap Manager icon changes from to
.
You can turn the computer on before connecting the ScanSnap.
There is no need to disconnect and reconnect the ScanSnap if it is already connected to
your computer.
There may be a slight delay before the ScanSnap Manager icon changes to
depending on your computer's performance, operating environment and load such as
when there are many programs running at the same time.
ADF paper chute (cover)

Fujitsu ScanSnap S1300 Specifications

General

Film scanning	No
Color scanning	Yes
Maximum scan size	216 x 360 mm
Scanner type	Sheet-fed scanner
Sensor type	CIS
ISO A-series sizes (A0...A9)	A4, A5, A6
ISO B-series sizes (B0...B9)	B5, B6
Maximum ISO A-series paper size	A4
Auto document feeder (ADF) input capacity	10 sheets
USB version	2.0
Standard interfaces	USB 2.0
Scan media weight	64 - 104.7 g/m²
Dimensions (WxDxH)	284 x 99 x 77 mm
Power requirements	AC 100 - 240V, 50/ 60 Hz
Non-operating relative humidity (non-condensing)	20 - 80 %
Minimum RAM	512 MB
Minimum storage drive space	2197 MB
Sustainability certificates	ENERGY STAR
Power consumption (standby)	5 W
Power consumption (typical)	9 W
Operating temperature (T-T)	5 - 35 °C
Certification	RoHS

Weight and Dimensions

Depth	99 mm
Width	284 mm
Height	77 mm
Weight	1400 g