Fujitsu ScanSnap S1300 User Manual

Turning the ScanSnap ON/OFF
25
Turning the ScanSnap ON/OFF
This section explains how to turn the ScanSnap ON/OFF.
The ScanSnap is turned ON/OFF in conjunction with the computer. Therefore, you do not
have to worry about turning the power ON/OFF as long as the ScanSnap is connected to a
computer.
zTurning the ScanSnap on
Open the ADF paper chute (cover) when the computer is turned on.
D The [Scan] button lights in blue, indicating that the ScanSnap is turned on.
zTurning the ScanSnap off
Turn off the computer or close the ADF paper chute (cover).
zScanSnap sleep mode
When the ScanSnap has not been in operation for one minute while the power is on, it
enters sleep (power saving) mode.
D The ScanSnap internal lamp switches off in sleep mode.
With some computers, the initialization of the ScanSnap may be performed several
times when the computer is started up.
z Close the ADF paper chute (cover) after storing the extension away.
z It may take two to three minutes until the light of the [Scan] button goes out after the
computer is turned off.

Fujitsu ScanSnap S1300 Specifications

General

Film scanning	No
Color scanning	Yes
Maximum scan size	216 x 360 mm
Scanner type	Sheet-fed scanner
Sensor type	CIS
ISO A-series sizes (A0...A9)	A4, A5, A6
ISO B-series sizes (B0...B9)	B5, B6
Maximum ISO A-series paper size	A4
Auto document feeder (ADF) input capacity	10 sheets
USB version	2.0
Standard interfaces	USB 2.0
Scan media weight	64 - 104.7 g/m²
Dimensions (WxDxH)	284 x 99 x 77 mm
Power requirements	AC 100 - 240V, 50/ 60 Hz
Non-operating relative humidity (non-condensing)	20 - 80 %
Minimum RAM	512 MB
Minimum storage drive space	2197 MB
Sustainability certificates	ENERGY STAR
Power consumption (standby)	5 W
Power consumption (typical)	9 W
Operating temperature (T-T)	5 - 35 °C
Certification	RoHS

Weight and Dimensions

Depth	99 mm
Width	284 mm
Height	77 mm
Weight	1400 g