Garmin G5 Install Manual & Pilot's Guide
190-02072-00 Rev. E
212
Pilot's Guide
Installation ManualPilot's GuideAppendixIndex
2.10 SYSTEM MESSAGES
Table 2-9 System Messages
Message Comments
Critical battery fault!
Powering off...
Battery has a critical fault condition and the unit is
about to power off to avoid damage to the battery.
Battery fault
Battery has a fault condition - examine fault display
in configuration mode and contact Garmin if it
persists.
Battery charger fault
Battery charger has a fault condition - examine fault
display in configuration mode and contact Garmin if
it persists.
Low battery
Battery charge level is low
Hardware fault
Unit has a hardware fault - contact Garmin for
service
Power supply fault
Unit power supply fault detected - contact Garmin
for service if it persists
Unit temperature limit
exceeded
Unit is too hot or too cold
Network address conflict
Another G5 with the same address is detected on
the network (most commonly a wiring error on one
of the units)
Communication error
General communication error (most commonly
appears in conjunction with Network Address
Conflict message)
Factory calibration data
invalid
Unit calibration data not valid - return to Garmin
Magnetic field model
database out of date
Internal magnetic field database is out of date -
software update required
Using external GPS data
GPS data from another network LRU is being used.
The unit's internal GPS receiver is enabled, but
unable to establish a GPS fix
Servo clutch fault
An autopilot servo is reporting a clutch monitor
fault
To Next Page
Loading...
Need help?
General
