Garmin G5 Install Manual & Pilot's Guide
190-02072-00 Rev. E 17
Unit Installation
Installation Manual Pilot's Guide Appendix Index
1.2.2.3 CABLE CONNECTOR INSTALLATION
A coaxial cable connection is required for the optional external GPS antenna.
1) Route the coaxial cable to the unit location. Secure the cable in accordance with
good aviation practices.
2) Trim the coaxial cable to the desired length and install the BNC connector. If
provided, follow the connector manufacturer’s instructions for cable preparation.
1.2.3 MECHANICAL CONSIDERATIONS
This section presents all information required for planning the physical layout of the
G5 installation.
1.2.3.1 PHYSICAL SPECIFICATIONS
Use Table 1-5 to determine panel requirements. All width, height, and depth
measurements are taken with unit mounting ring and connectors (if applicable).
Table 1-5 G5 Physical Specifications
Configuration Width Height Depth* Unit Weight Weight of
Unit and
Connector**
G5 3.42 in 3.60 in 2.61 in 0.55 lb 0.70 lb
G5 with Battery 3.42 in 3.60 in 3.03 in 0.83 lb 0.98 lb
*Depth behind aircraft panel
**Weight includes mounting ring
To Next Page
Loading...
Need help?
General
