GE EST iO64 User Manual

Chapter 3: Programming
EST iO64 and iO500 Technical Reference Manual 143
Printer programming
If a printer is connected to your system, it must be programmed
with the printer type and event notification. Event notification
controls where printer trouble events are sent and displayed.
Panel Configuration
Annunciator
CMS Device
Printer
⇩
Printer
Type Supervised>
Event Notification
Save
⇩
Printer
Type Supervised>
Event Notification
Save
⇩
Trouble
Printer Yes<>
Dialer Account 1&2
NET Yes<>
⇩
Trouble
NET Yes
CID 110
Save
⇩
To program a printer:
1. Access the panel configuration options menu. See "Panel
configuration options."
2. Choose Printer.
3. Choose Type.
4. Select the type of printer.
Supervised: The printer connection is supervised (see the
printer's switch settings)
Unsupervised: The printer connection is not supervised
None/CU: There is no printer or you are connecting a computer
running the configuration utility to the panel
5. Choose Event Notification.
6. Set printer trouble event notification. See "Factory default
settings" for printer event notification default settings.
Printer: Yes or No. Specifies if event information is printed
Dialer:
Acct 1 & 2: Event information is sent to both dialer accounts
Acct 1: Event information is sent to dialer account one
Acct 2: Event information is sent to dialer account two
None: Event information is not sent to the dialer
NET: Yes or No. Specifies if event information is sent to the
connected network
CID: Contact ID event code (000 to 999)
7. When finished, choose Save.
8. Choose Save (on the Printer menu).
9. Continue programming your system or press Menu to exit menu
mode.
Printer
Type Supervised>
Event Notification
Save

GE EST iO64 Specifications

General

Brand	GE
Model	EST iO64
Category	Control Panel
Language	English