Battery Exchange
The supply of the device from the Li-Ion battery pack delivered with the
device (high capacity, good temperature characteristic and very low self-discharge)
is recommended. Alternatively the supply from six alkaline cells of AA size (with
the help of the battery holder from standard accessories) can be used.
If you want to change the batteries, unscrew four screws and remove rear
panel of Bluetooth adapter. Then take out the Li-Ion battery pack, insert a new Li-
Ion battery pack or battery holder instead and mount the rear panel back.
Assembling the Bluetooth adapter and the probe
Put Bluetooth adapter onto the probe close to the connector, fix it by means
of rubber ring and connect it with the probe with short cable from accessories.
Adapter is switched ON by Power switch, indicator Power ON shows that
adapter is turned on. It is necessary to do it before the control unit is turned on. No
setting of the control unit is needed – the connection passes automatically.
No Bluetooth connection with GPS is available when Bluetooth is used for
connection with the probe.
To Next Page
Loading...
Need help?
General
