35
4 - Sprayer setup
General info
Before Putting the Sprayer into Operation
Although the sprayer has been supplied with a strong and protective surface treatment on steel parts, bolts etc. in the
factory, it is recommended to apply a film of anticorrosion oil (e.g. CASTROL RUSTILO or SHELL ENSIS FLUID) on all metal parts
in order to avoid chemicals and fertilizers discolouring the enamel.
If this is done before the sprayer is put into operation for the first time, it will always be easy to clean the sprayer and keep
the enamel clean for many years. This treatment should be carried out every time the protection film is washed off.
Support Leg
The support leg is stored in the bracket on the sprayer’s right side when
the sprayer is attached to the tractor.
To use the support leg
1. Lift the leg off the storage bracket.
2. The support leg can then be mounted to the drawbar extension
on both sides as preferred (high hitch left side only).
3. Secure with the linchpin.
To remove the support leg
1. Lift the leg.
2. Remove the linchpin and pull out the support leg.
3. Secure the leg at the storage bracket with the linchpin.
Jack Up the Sprayer
When the sprayer needs wheel mounting, wheel changing, brake or
wheel bearing changing etc. then jack up the sprayer under the axle as
shown.
€
DANGER! Be sure to place sprayer at level and firm ground to
avoid sprayer falling down from the jack.
μ
ATTENTION! It is good practice to use stop wedges at the
opposite wheel!
To Next Page
Loading...
Need help?
General
