Higen FDA7002EX User Manual

3. Parameter setting
3-4
StE-18
PROG Version
Unit
-
Setting range
0.0 ~ 99.99
Manufactured
default
-
Speed/Torque/
Position control
This menu displays encoder type, program version and drive capacity.
AC 220V
AC 380V
AC 440V
AC 110VL1
S
H0
H1
500W~1kW
1.5~4.5kW
7.5kW
100~400W
h
11kWE
VoltageSym. PowerSym.
15kWF
Input Voltage Power
Firmware Virsion
VirsionSym.
Standard2.00~2.99
Spectial Order3.00~9.99
PowerSym.
StE-19
Single Turns DEG
Unit
DEG
Setting range
0.000 ~ 359.999
Manufactured
default
Speed/Torque/
Position control
When using a 17bit serial encoder, the position unit for one revolution is displayed as dgree.
StE-20
Warning Status
Unit
-
Setting range
0 ~ 1023
Manufactured
default
Speed/Torque/
Position control
Combination of current warnings on the servo drive is displayed in hexadecimal.
(E.g. 0000 = no alerts currently occurring, 0005 = 1, 3 alerts)
The bit allocation of the warning content is shown below.
Bit-9
Bit-0
No.
10
9
8
7
6
5
4
3
2
1
Warning
Reser
-ved
Reser
-ved
Reser
-ved
Reser
-ved
Reser
-ved
Reser
-ved
Reser
-ved
Reser
-ved
Reser
-ved
Low-
Battery
StE-21
CYCLE TIME
Unit
ms
Setting range
0 ~ 99999.9
Manufactured
default
0.0
Speed/Torque/
Position control
Enter the time for calculating the StE-22 [Cycle Average Load Factor].
StE-22
CYCLE LOAD RATE
Unit
%
Setting range
-300.0 ~ 300.0
Manufactured
default
Speed/Torque/
Position control
The average load rate for the time set by StE-22 [Cycle Time] is displayed.

Higen FDA7002EX Specifications

General

Brand	Higen
Model	FDA7002EX
Category	Servo Drives
Language	English