Network Video Recorder User Manual
146
Thermal Camera Detection
The NVR supports the event detection modes of the thermal network cameras: fire and smoke
detection, temperature detection, temperature difference detection, etc.
Before you start
Add the thermal network camera to your device and make sure the camera is activated.
Go to System > Event > Smart Event.
Select a thermal camera from the camera list.
(Optional) Check Save VCA Picture to save the captured pictures of detection.
Select an event detection (Temperature, etc.).
Set the arming schedule. Refer to Chapter 11.1 Configure Arming Schedule.
Set the linkage actions. Refer to Chapter 11.2 Configure Alarm Linkage Actions.
Click Apply.
Queue Management
After connecting the device with queue management camera, you can set the arming schedule
and linkage action of queue management.
Before you start
Ensure you have connected the device with queue management camera, and the camera is online.
Go to System > Event > Smart Event.
Select a queue management camera from the camera list.
(Optional) Check Save VCA Picture to save the captured pictures of detection.
Set the arming schedule. Refer to Chapter 11.1 Configure Arming Schedule.
Set the linkage actions. Refer to Chapter 11.2 Configure Alarm Linkage Actions.
Click Apply.
To Next Page
Loading...
Need help?
General
