HIKVISION iDS-7200AHQHI-M Series User Manual

Restore Defaults
Restore all parameters, except the network (including IP address, subnet mask, gateway,
MTU, NIC working mode, default route, server port, etc.) and user account parameters, to
the factory default sengs.
Factory Defaults
Restore all parameters to the factory default sengs.
Restore to Inacve
Restore the recorder to inacve status.
Note
The recorder will reboot automacally aer restoring to the default sengs.
11.9 Security Management
Enter a short descripon of your concept here (oponal).
This is the start of your concept.
11.9.1 HTTP
Authencaon
If you need to enable the HTTP service, you can set HTTP authencaon to enhance access
security.
Steps
1. Go to System → System Service → System Service .
Figure 11-13 HTTP
Authencaon
2. Check Enable HTTP.
3. Select HTTP Authencaon Type.
Note
Two authencaon types are selectable, for security reasons, it is recommended to select
digest as the authencaon type.
4. Click Apply to save the sengs.
5. Restart the device to take eect the sengs.
ATM Digital Video Recorder User Manual
95

HIKVISION iDS-7200AHQHI-M Series Specifications

General

Brand	HIKVISION
Model	iDS-7200AHQHI-M Series
Category	DVR
Language	English