HIKVISION iDS-7200AHQHI-M Series User Manual

Note
• You can use the default port No., or change it according to actual requirements.
• External Port indicates the port No. for port mapping in the router.
• The value of the RTSP port No. should be 554 or between 1024 and 65535, while the value of
the other ports should be between 1 and 65535 and the value must be
dierent from each
other. If mulple devices are congured for the UPnP™ sengs under the same router, the
value of the port No. for each device should be unique.
4. Enter the virtual server seng page of router; ll in the blank of Internal Source Port with the
internal port value, the blank of External Source Port with the external port value, and other
required contents.
Note
• Each item should be corresponding with the device port, including server port,
hp port,
RTSP port and hps port.
• The virtual server seng interface below is for reference only, it may be dierent due to
dierent router manufactures. Please contact the manufacture of router if you have any
problems with
seng virtual server.
Figure 7-6 Seng Virtual Server Item
7.7 Congure ONVIF
ONVIF protocol allows the connecon with third-party cameras. The added user accounts have the
permission to connect other devices via ONVIF protocol.
Steps
1. Go to System → System Service → ONVIF .
2. Check Enable ONVIF to enable the ONVIF access management.
Note
ONVIF protocol is disabled by default.
3. Click Add.
4. Enter User Name, and Password
ATM Digital Video Recorder User Manual
64

HIKVISION iDS-7200AHQHI-M Series Specifications

General

Brand	HIKVISION
Model	iDS-7200AHQHI-M Series
Category	DVR
Language	English