Setting up configuration environment
2
A.1
Setting up DHCP/BOOTP server
Basic - L3P
Release
4.0
11/07
A.1 Setting up DHCP/BOOTP
server
On the CD-ROM supplied with the Switch you will find the software for a
DHCP server from the software development company IT-Consulting Dr.
Herbert Hanewinkel. You can test the software for 30 calendar days from the
date of the first installation, and then decide whether you want to purchase a
license.
To install the DHCP servers on your PC, put the CD-ROM in the CD drive
of your PC and under Additional Software select "haneWIN DHCP-Serv-
er". To carry out the installation, follow the installation assistant.
Start the DHCP Server program.
Figure 61: Start window of the DHCP server
Note: The installation procedure includes a service that is automatically
started in the basic configuration when Windows is activated. This service is
also active if the program itself has not been started. When started, the ser-
vice responds to DHCP queries.
Open the window for the program settings in the menu bar: Op-
tions:Preferences and select the DHCP tab page.
Enter the settings shown in the illustration and click OK.
To Next Page
Loading...
Need help?
General
