Section 4 Unpacking, inspecting and storing
4.1 Removing transport packaging
AMU0600514 v5
IEDs require careful handling.
1. Examine the delivered products to ensure that they have not been damaged during the transport.
2. Remove the transport packing carefully without force.
The cardboard packaging material is 100% recyclable.
4.2 Inspecting the product
4.2.1 Identifying the product
AMU0600513 v5
1. Locate the IED's order number from the label attached to the IED's case.
2. Compare the IED's order number with the ordering information to verify that the received product is
correct.
4.2.2 Checking delivery items
GUID-2A6D8F5A-470F-40D1-9EAE-60DE4DD85EE6 v1
Check that all items are included in the delivery in accordance with the delivery documents.
4.2.3 Inspecting the IED
GUID-F6333353-F05D-4B41-BE44-5CE5274E788E v2
• Check the IED to see if any damage occurred during transportation.
4.2.4 Returning an IED damaged in transit
GUID-966A05ED-CD30-4F66-957E-00FF38943A73 v6
If damage has occurred during transport, appropriate actions must be taken against the latest carrier.
Please inform the nearest Hitachi Energy office or representative. Notify Hitachi Energy immediately if
there are any discrepancies in relation to the delivery documents.
4.3 Storing
GUID-1DC9D33D-DC62-438B-9333-3BB354164CBC v7
If the IED is stored before installation, it must be done in the original transport casing in a dry and dust
free place in accordance with ANSI C37.90.0. Storage temperature must be within the range of -40° C to
+70° C. The average high temperature is recommended to be less than +40° C, to minimize component
ageing.
1MRK514026-UUS Rev. P Section 4
Unpacking, inspecting and storing
670 series 17
Installation manual
© 2017 - 2023 Hitachi Energy. All rights reserved
To Next Page
Loading...
Need help?
General
