207
uuSecurity SystemuUltrasonic Sensors
*
Ultrasonic Sensors
*
The ultrasonic sensors activate only when the security system alarm is set. If the
sensors detect an intruder moving around inside or entering the interior of the
vehicle through a window, the sensor will activate the alarm.
■ To set the security system alarm without activating the ultrasonic sensors
You can set the security system alarm without activating the ultrasonic sensors.
To turn off the ultrasonic sensor system, press
the ultrasonic sensor OFF button after you
remove the key from the ignition switch, or
with the key in the ACCESSORY
(q or LOCK
(0
*1
.
u The is on in red.
To turn it on again, press the ultrasonic sensor
OFF button.
Ultrasonic sensors is turned on every time you
set the security system alarm, even if you
turned it off the last time.
*1: Models with the keyless access system have an ENGINE START/STOP button instead of an
ignition switch.
1Ultrasonic Sensors
*
Whether the ultrasonic sensors has been activated or
not, the security system can only be turned off by the
remote transmitter or keyless access system
*
, not the
key.
It is possible to confirm whether the vehicle security
system was activated without your knowledge. If the
security system has been activated, the will blink
for 5 minutes after you unlock the door and disable
the system.
If, however, you start the engine, the will stop
blinking after 5 seconds.
If the ultrasonic sensor is malfunctioning or there is
another problem, the will come on for 5 minutes
after you unlock the door and disable the system.
If, however, you start the engine, the will shut
off.
The security system may accidentally activate by
ultrasonic sensors such as when:
• Someone is in the vehicle
• A window is open
• Accessories or clothes are hanging in the vehicle.
Ultrasonic Sensor OFF Button
* Not available on all models
19 CR-V PET JSS (KE KG)-32TLA6000.book 207 ページ ２０１８年７月２３日 月曜日 午後６時８分
To Next Page
Need help?
General
