Continued
739
uuIf a Tyre Goes FlatuChanging a Flat Tyre
2. Turn the end bracket clockwise as shown in
the image until the top of the jack contacts
the jacking point.
u Make sure that the jacking point tab is
resting in the jack notch.
3. Raise the vehicle, using the jack handle bar
and the jack handle, until the tyre is off the
ground.
1How to Set Up the Jack
Do not use the jack with people or luggage in the
vehicle.
Use the jack provided in your vehicle.
Other jacks may not support the weight (“load”) or
may not fit the jacking point.
The following instructions must be followed to use
the jack safely:
• Do not use while the engine is running.
• Use only where the ground is firm and level.
• Use only at the jacking points.
• Do not get in the vehicle while using the jack.
• Do not put anything on top of or underneath the
jack.
Jack
Handle
Bar
Wheel Nut
Wrench as Jack Handle
19 CR-V PET JSS (KE KG)-32TLA6000.book 739 ページ ２０１８年７月２３日 月曜日 午後６時８分
To Next Page
Loading...
Need help?
General
