Honeywell MultiRAE Series User Manual

Charging with The Travel Charger
The Travel Charger is a lightweight portable alternative to the Desktop Cradle for charging and
PC communications. Follow these steps to use the Travel Charger.
Before attaching the Travel Charger, check that it is aligned correctly with the base of the
MultiRAE. There are two alignment pins on one side and one alignment pin on the other side,
designed to mate with matching points on the bottom of the MultiRAE:
1. Check bottom of MultiRAE Travel Charger’s alignment pins
for correct orientation with the MultiRAE.
2. Align Travel Charger with
bottom of MultiRAE.
3. Press Travel Charger onto bottom
of MultiRAE.
4. Make sure the Travel Charger clicks into place and
attaches firmly.
Next, put the plug from the power supply into the jack on the side of the Travel Charger:
Plug the other end of the charger into a power source (AC outlet or 12VDC mobile power port,
depending on the model). When power is applied and the MultiRAE’s battery is charging, the
LED glows red. The LED glows green when the battery is fully charged.
Carrying the MultiRAE In A Vehicle
The MultiRAE Truck Mount (PN M01-0307-000), used in conjunction with the front part of the
Desktop Cradle (PN M01-0306-000), provides an NFPA requirement-compliant way to mount
and carry the MultiRAE in a vehicle.
CAUTION!
Do not use the Truck Mount in hazardous locations.
Honeywell MultiRAE Series™ 43 User Manual

Honeywell MultiRAE Series Specifications

General

Brand	Honeywell
Model	MultiRAE Series
Category	Gas Detectors
Language	English