Xenon/Granit User Guide 147
LED Solid (No Flash)
Under normal operations, the scanner’s LED flashes once for a good read. You may
set the LED to remain on for a length of time after a good read instead of flashing.
Default = LED Solid Off (Resume Flash).
If you have scanned a bar code and don’t want to wait for the LED to turn off, press
the trigger a 2nd time and the LED turns off. You can then scan the next bar code.
Page Volume Control
Note: This setting is not supported by the Xenon 1900h scanner.
When you press the Page button on the base or Access Point, the scanners associ-
ated with that base or Access Point will begin beeping in response. If you pull the
trigger on a scanner that is beeping in response, or press the Page button on the
base or Access Point a second time, all associated scanners will stop beeping. The
following settings set the paging volume, independent of the volume used when
scanning bar codes. Default = Low.
* LED Solid Off
(Resume Flash)
To Next Page
Loading...
Need help?
General