46 Xenon/Granit User Guide
Page Button and Presentation Modes
When in Streaming Presentation Mode, the scanner’s aimer goes out after a short
time, but the scan illumination remains on all the time to continuously search for
bar codes (see Streaming Presentation™ Mode on page 124). When in Temporary
Streaming Presentation Mode, pressing the page button on the base puts the
scanner into Streaming Presentation Mode until the timeout occurs. If a bar code is
scanned before the timeout is reached, the timer starts over.
When the scanner is in the base, press the page button once to put the scanner
into Temporary Streaming Presentation Mode. When the scanner is in the base and
the base has external power (plugged into an outlet), press the page button twice
to put the scanner into Streaming Presentation Mode. Press it twice again to end
Streaming Presentation Mode. When the base does not have external power, press-
ing the page button twice does not trigger Streaming Presentation Mode.
When the scanner is out of the base, the page button works normally. Default =
Temporary Streaming Presentation Mode On.
To remove Temporary Streaming Presentation Mode, scan the bar code for * Page
Mode On on page 52.
Temporary Streaming Presentation Timeout
Set a timeout for the length of time the illumination remains on and searching for
bar codes when using Temporary Streaming Presentation Mode. Set the length for
the timeout by scanning one of the bar codes below. Default = 10,000 ms (10 sec-
onds).
* Temporary Streaming Presentation Mode
On
To Next Page
Loading...
Need help?
General