264 Xenon/Granit User Guide
Menu Commands
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page
Product Default Settings
Set Custom Defaults Set Custom Defaults MNUCDP 12
Save Custom Defaults MNUCDS 12
Reset the Custom Defaults Activate Custom Defaults DEFALT 13
Reset the Factory Defaults -
cordless scanners
Factory Default Settings:
All Application Groups
PAPDFT& 68
Reset the Custom Defaults -
cordless scanners
Custom Default Settings:
All Application Groups
PAPDFT 69
Program the Interface
Plug and Play Codes Keyboard Wedge:
IBM PC AT and Compatibles with
CR suffix (not supported by Granit
1980i)
PAP_AT 15
Laptop Direct Connect with CR
suffix (not supported by Granit
1980i)
PAPLTD 16
RS232 Serial Port PAP232 16
Plug and Play Codes:
RS485
IBM Port 5B Interface PAPP5B 16
IBM Port 9B HHBCR-1 Interface PAP9B1 16
IBM Port 17 Interface PAPP17 17
IBM Port 9B HHBCR-2 Interface PAP9B2 17
RS485 Packet Mode On RTLPDF1 17
RS485 Packet Mode Off RTLPDF0 17
RS485 Packet Length (20-256) RTLMPS 18
Plug and Play Codes: IBM SurePos USB IBM SurePos Handheld PAPSPH 18
USB IBM SurePos Tabletop PAPSPT 18
Plug and Play Codes: USB USB Keyboard (PC) PAP124 18
USB Keyboard (Mac) PAP125 19
USB Japanese Keyboard (PC) TRMUSB134 19
USB HID PAP131 19
USB Serial TRMUSB130 19
CTS/RTS Emulation On USBCTS1 19
CTS/RTS Emulation Off* USBCTS0 20
ACK/NAK Mode On USBACK1 20
ACK/NAK Mode Off* USBACK0 20
Remote MasterMind for USB ReM Off REMIFC0 20
ReM On REMIFC1 20
To Next Page
Need help?
General