Xenon/Granit User Guide 49
LED = error; green LED = success of any type. Scanners and the CCB01-010BT
base have audible indicators as well: 1 razz or error tone = error; 2 beeps = menu
change; 1 beep = all other successes.
The table below lists the indication and cause of the LED indication, beeps, and
vibrations for the scanner.
Scanner LED Sequences and Meaning
Base/Access Point LED Sequences and Meaning
The base contains a red LED and the Access Point has a blue LED that indicate the
status of the unit and verifies its communication with the host system. The base
also has a green LED that indicates scanner battery charge condition.
LED Indication
Beeper
Indication
Vibrate
Indication
Cause
Normal
Operation
Red Flash None None Battery low
Green Flash 1 beep None Successful communication or
linking
Red, blinking Razz or error tone None Failed communication
Menu Operation
Green Flash 2 beeps 2 vibrations Successful menu change
Red, blinking Razz or error tone 1 long vibration Unsuccessful menu change
Red or Blue LED - Host Communication
Red or Blue LED Communication Condition
Off USB suspend
On continuously Power on, system idle
Short blinks in multiple pulses. Occurs while transferring data to/
from the RF module or the Host port.
Receiving data
Green LED - Scanner Battery
(base only, does not apply to Access Point)
Green LED Charge Condition
Off Battery not detected or charge
suspended
Slow flash, 1 second on, 1 second off Pre-charge and charging
On continuously Charge complete
Fast flash, 300 mSec on, 300 mSec off Charge Error
To Next Page
Loading...
Need help?
General