8 Xenon/Granit User Guide
Connect with RS485
A Xenon scanner or cordless base can be connected for an IBM POS terminal inter-
face. (This interface is not available in the Granit devices.)
1. Connect the appropriate interface cable to the device, then to the computer.
Note: The power supply must be ordered separately, if needed.
2. Make sure the cables are secured in the wireways in the bottom of the cordless
base and the base sits flat on a horizontal surface.
3. Turn the terminal/computer power back on. The scanner beeps.
4. Verify the scanner or cordless base operation by scanning a bar code from the
Sample Symbols, beginning on page 339. The scanner beeps once. If using a
Granit scanner, it also vibrates.
For further RS485 settings, refer to RS485,page 16.
Corded Xenon Scanner
RS485 Connection:
CCB01-010BT/CCB01-010BT-BF Base
RS485 Connection:
To Next Page
Loading...
Need help?
General