Model 1332A
SECTION
II
INSTALLATION
Installation
2-1. INTRODUCTION.
directly above each drawing is the part number for an
instrument power cord equipped with a connector of
2-2. This section contains information and instruc-
that configuration. If the appropriate power cord is not
tions necessary for installing the Model
1332A. included with the instrument, notify the nearest HP
Included are initial inspection procedures, power
Sales/Service Office and a replacement cord will be
requirements, systems application information, and
provided.
instructions for repacking for shipment.
2-3. INITIAL INSPECTION.
2-4. This instrument was carefully inspected both
mechanically and electrically before shipment. It should
be free of mars or scratches and in perfect electrical
order upon receipt. To confirm this, the instrument
should be inspected for physical damage incurred in
transit. If the instrument was damaged in transit, file a
claim with the carrier. Check for
su~plied accessories
(paragraph 1-8) and test the electrical performance of
the instrument using the performance test procedures
outlined in Section
V.
If there is damage or deficiency,
see the warranty in the front of this manual.
2-5. POWER REQUIREMENTS.
2-6. The 1332A operates from any power source sup-
plying 100, 120, 220, or 240
Vac (+5% -lo%), single
phase, 48 Hz to 440 Hz that can deliver approximately
50 VA of power.
2-10.
SYSTEM APPLICATIONS.
This instrument is
designed and manufactured primarily for OEM systems
and is shipped without protective covers.
WARNING
a
Operator protection from hazardous volt-
ages within the instrument must be pro-
vided by the system in which the instru-
ment is to be used.
2-11. REPACKING FOR SHIPMENT.
2-12. If the instrument is to be shipped to a Hewlett-
Packard Sales/Service Office for service or repair,
attach a tag showing owner (with address), complete
instrument serial number, and a description of the
service required.
2-7. The instrument is normally shipped from the
2-13. Use the original shipping carton and packing
factory set to operate at 120
Vac. To operate from any
material. If the original packing material is not
avail-
of the other sources, proceed as follows:
able, the Hewlett-Packard
Sales/Service Office will
provide information and recommendations on materials
a. Remove power cord (if connected). to be used.
b. Set switch on rear panel to desired voltage.
c. For 220
Vac or 240 Vac, remove 0.75-ampere
8120-1692 81 20-1369 81 20-1703 8120-1538
fuse (HP Part No. 2110-0063) and replace with 0.375-
ampere fuse (HP Part No. 2110-0065).
d. Connect power cord.
2-8. POWER CORDS AND RECEPTACLES.
STD-B-2878
2-9. Figure 2-1 illustrates the standard configura-
tions used for HP power cords. The HP Part Number
Figure
2-1.
Power Receptacles
2-1/(2-2 blank)
Scans by ArtekMedia © 2008
To Next Page
Loading...
Need help?
General