6-23
Optimizing Port Usage Through Traffic Control and Port Trunking
Port Trunking
Optimizing Port Usage
Through Traffic Control and
Removing Ports from a Dynamic LACP Trunk Group. To remove a port
from dynamic LACP trunk operation, you must turn off LACP on the port. (On
a port in an operating, dynamic LACP trunk, you cannot change between LACP
dynamic and LACP passive without first removing LACP operation from the
port.)
Caution Unless STP is running on your network, removing a port from a trunk can
result in a loop. To help prevent a broadcast storm when you remove a port
from a trunk where STP is not in use, HP recommends that you first disconnect
the link on that port.
Syntax: no interface <port-list> lacp
In this example, port 1 belongs to an operating, dynamic LACP trunk. To
remove port 1 from the dynamic trunk and return it to passive LACP, you would
do the following:
HP2512>(config)# no interface 1 lacp
HP2512>(config)# interface 1 lacp passive
Note that in the above example, if the port on the other end of the link is
configured for active LACP or static LACP, the trunked link will be re-
established almost immediately.
Web: Viewing Existing Port Trunk Groups
While the web browser interface does not enable you to configure a port trunk
group, it does provide a view of an existing trunk group.
To view any port trunk groups:
Click on the Status tab.
Click on [Port Status].
To Next Page
Loading...
Need help?
General