A-7
Transferring an Operating System or Startup Configuration File
Downloading an Operating System (OS)
Transferring an Operating
System or Startup
CLI: Switch-To-Switch Download
Syntax: copy tftp flash <ip-addr> flash
For example, to download an OS file from a Switch 2512 with an IP address
of 10.28.227.103:
Figure 8-17.Switch-To-Switch OS Download Using the CLI
Using Xmodem to Download the OS File From a PC
This procedure assumes that:
â– The switch is connected via the Console RS-232 port on a PC operating as
a terminal. (Refer to the Installation Guide you received with the switch
for information on connecting a PC as a terminal and running the switch
console interface.)
â– The switch operating system (OS) is stored on a disk drive in the PC.
â– The terminal emulator you are using includes the Xmodem binary transfer
feature. (For example, in the Windows NT terminal emulator, you would
use the Send File option in the T
ransfer dropdown menu.)
Menu: Xmodem Download
1. From the console Main Menu, select
7. Download OS
2. Press [E] (for E
dit).
3. Use the Space bar to select XMODEM in the Method field.
4. Press [Enter], then [X] (for eX
ecute) to begin the OS download. The following
message then appears:
Press enter and then initiate Xmodem transfer
from the attached computer.....
5. Execute the terminal emulator command(s) to begin Xmodem binary
transfer.
Running Total
of Bytes
Downloaded
To Next Page
Loading...
Need help?
General