9-5
Configuring Advanced Features
HP ProCurve Stack Management
Configuring Advanced
Features
HP ProCurve Stack Management
Stacking Features
HP ProCurve Stack Management (termed stacking) enables you to use a single
IP address and standard network cabling to manage a group of up to 16 total
switches in the same IP subnet (broadcast domain). Using stacking, you can:
■ Reduce the number of IP addresses needed in your network.
Feature Default Menu CLI Web
view stack status
view status of a single switch n/a page 9-29
thru
page 9-31
page 9-34 page 9-48
view candidate status n/a page 9-34
view status of commander and its
stack
n/a page 9-35
view status of all stacking-enabled
switches in the ip subnet
n/a page 9-35
configure stacking
enable/disable candidate Auto-Join enabled/Yes page 9-18 page 9-40
“push” a candidate into a stack n/a page 9-18 page 9-40
configure a switch to be a commander n/a page 9-15 page 9-36
“push” a member into another stack n/a page 9-27 page 9-42
remove a member from a stack n/a page 9-24 page 9-43
or
page 9-44
“pull” a candidate into a stack n/a page 9-20 page 9-39
“pull” a member from another stack n/a page 9-22 page 9-41
convert a commander or member to a
member of another stack
n/a page 9-27 page 9-42
access member switches for
configuration and traffic monitoring
n/a page 9-26 page 9-45
disable stacking enabled page 9-18 page 9-47
transmission interval 60 seconds page 9-15 page 9-47
To Next Page
Loading...
Need help?
General