7-29
Using Passwords, Port Security, and Authorized IP Managers To Protect Against Unauthorized Access
Configuring and Monitoring Port Security
Using Passwords, Port
Security, and Authorized IP
Proxy Web Servers. If you are using the switch’s web browser interface
through a switch port configured for Static port security, and your browser
access is through a proxy web server, then it is necessary to do the following:
■ Enter your PC or workstation MAC address in the port’s Authorized
Addresses list.
■ Enter your PC or workstation’s IP address in the switch’s IP Authorized
Managers list. See “Using IP Authorized Managers” on page 7-30.)
Without both of the above configured, the switch detects only the proxy
server’s MAC address, and not your PC or workstation MAC address, and
interprets your connection as unauthorized.
“Prior To” Entries in the Intrusion Log. If you reset the switch (using
the Reset button, Device Reset, or Reboot Switch), the Intrusion Log will list
the time of all currently logged intrusions as “prior to” the time of the reset.
Alert Flag Status for Entries Forced Off of the Intrusion Log. If the
Intrusion Log is full of entries for which the alert flags have not been reset, a
new intrusion will cause the oldest entry to drop off the list, but will not change
the alert flag status for the port referenced in the dropped entry. This means
that, even if an entry is forced off of the Intrusion Log, no new intrusions can
be logged on the port referenced in that entry until you reset the alert flags.
To Next Page
Loading...
Need help?
General