5-8
Configuring IP Addressing, Interface Access, and System Information
IP Configuration
Configuring IP Addressing,
Interface Access, and
Viewing the Current IP Configuration. The following command displays
the IP addressing for each VLAN configured in the switch. If only the
DEFAULT_VLAN exists, then its IP configuration applies to all ports in the
switch. Where multiple VLANs are configured, the IP addressing is listed per
VLAN. The display includes switch-wide packet time-to-live, and (if config-
ured) the switch’s default gateway and Timep configuration.
Syntax: show ip
For example, in the factory-default configuration (no IP addressing assigned),
the switch’s IP addressing appears as:
Figure 5-2. Example of the Switch’s Default IP Addressing
With multiple VLANs and some other features configured, show ip provides
additional information:
Figure 5-3. Example of Show IP Listing with Non-Default IP Addressing Configured
(If DHCP/Bootp acquires an IP address and Subnet Mask for VLAN_2, they
will appear in the appropriate columns.)
The Default IP
Configuration on
a Switch 2512 or
2524
A Switch 2512 or
2524 with IP
Addressing and
VLANs Configured
To Next Page
Loading...
Need help?
General