HP ProLiant DL320 Generation 2 User Manual

Removal and Replacement Procedures
Processor
CAUTION: Always use a new heatsink when replacing processors. Failure to use new
components can cause damage to the processor.
To remove the processor:
1. Power down the server. See “Powering Down the Server” in this chapter.
2. Remove the access panel. See “Access Panel” in this chapter.
3. Locate the processor on the system board.
Figure 2-31: Locating the processor on the system board (center
wall removed for clarity)
WARNING: To reduce the risk of personal injury from hot surfaces, al
low the internal
system components to cool before touching them.
CAUTION: The processor socket must be populated at all times. Failure to replace the
processor results in the system failing to boot and halting during the POST. This error
prevents the system from functioning properly.
HP ProLiant DL320 Generation 2 Server Maintenance and Service Guide 2-37
HP

HP ProLiant DL320 Generation 2 Specifications

General

Brand	HP
Model	ProLiant DL320 Generation 2
Category	Server
Language	English