Specifications
Power Supply
Table 5-2: Power Supply Specifications
Item Description
Input voltage specifications
Rated input voltage 100 VAC to 240 VAC
Rated input line 180 VAC to 264 VAC (90 VAC to 132 VAC)
Frequency range 47 to 63 Hz
Rated input power 307 W
Rated input current 3.3 A, 1.7 A (110 V, 220 V)
Steady state power 180 W
Maximum peak power 200 W for two minutes
Ambient temperature range
Operating
10°C to 35°C (50°F to 95°F)
Non-operating
-40°C to 70°C (-40°F to 158°F)
Relative humidity (non-condensing)
Operating 10% to 90%
Non-operating 5% to 95%
Dielectric voltage withstand
Input to output 3000 VAC/minute
Input to ground 1500 VAC/minute
Maximum wet-bulb temperature
28°C (82.4°F)
Memory
Table 5-3: SDRAM DIMM Specifications
Item Description
Size 128 MB, 256 MB, 512 MB and 1GB
Speed 200/266 MHz
Width 64 bits
Type PC2100 ECC registered DDR SDRAM DIMMs
Note: DIMMs must be industry-standard 184-pin PC2100 DDR DIMMs. The DDR DIMMs must
support CAS Latency 2, or greater. They must also contain the mandatory Joint Electronic Device
Engineering Council (JEDEC) Serial Presence Detect (SPD). Use HP supplied SDRAM only.
HP ProLiant DL320 Generation 2 Server Maintenance and Service Guide 5-3
To Next Page
Loading...
Need help?
General