Warning events
Table 53 Warning event codes
Details and SolutionDescriptionEvent code
The application software made an illegal
request.
SCSI: transport element full30
SCSI: all slots empty31
SCSI: invalid opcode32
SCSI: invalid element address33
SCSI: invalid field in CDB34
SCSI: invalid drive specified35
SCSI: SEND DIAGNOSTIC command: invalid
test number
36
SCSI: invalid LUN37
SCSI: parameter list length error38
SCSI: parameter list error: invalid field39
SCSI: parameter list error: parameter not
supported
3A
The application software made an illegal
request.
SCSI: parameter value invalid3B
SCSI: saving parameters not supported3C
SCSI: invalid ID message3D
SCSI: destination element full3E
SCSI: source slot or drive empty3F
SCSI: wrong checksum40
SCSI: command sequence error41
The application software requested to use a
drive that is disabled. Check the device
configuration.
SCSI: drive disabled42
The application software requested to use the
mailslot, but the mailslot is disabled. Check
the device configuration.
SCSI: mailslot disabled43
Troubleshooting206
To Next Page
Loading...
Need help?
General