HP StorageWorks S1000 - NAS User Manual

Folder and Share Management
102 NAS 1000s Administration Guide
2. Protocols and their statuses are listed. The following options are available:
■ Enabling a protocol
■ Disabling a protocol
■ Modifying Protocol Settings
Because enabling and disabling a protocol are self explanatory, only modifying protocol
specific settings is described in this section.
CIFS Protocol Settings
There are no user configurable settings for CIFS.
NFS Protocol Settings
NFS is the networking protocol for exporting UNIX file systems across a network. UNIX and
NFS are discussed in Chapter 6, UNIX File System Management.
Some of the NFS protocol settings include:
■ Async/Sync Settings
■ Locks
■ Client Groups
■ User and Group Mappings
FTP Protocol Settings
Three tabs are presented in the FTP Protocol Properties dialog box: Logging, Anonymous
Access, and Messages.
Within these tabs:
■ Logging—Enable logging
■ Anonymous Access—Enable anonymous access
■ Messages—Enter a welcome and an exit message
HTTP Protocol Settings
The following parameters can be set for Web protocols:
■ Indicate which IP addresses can be used to access data shares
■ Indicate which port can be used to access data shares
NCP (NetWare) Protocol Settings
There are no user configurable settings for NCP.

HP StorageWorks S1000 - NAS Specifications

General

Manufacturer	HP
Model	StorageWorks S1000
Supported Drive Types	SATA
RAID Support	Yes
Category	NAS
RAID Levels	0, 1, 5, 10
Network Interfaces	2 x Gigabit Ethernet
Interfaces	2 x USB 2.0
Protocols	CIFS, NFS, FTP, HTTP, iSCSI