Folder and Share Management
99NAS 1000s Administration Guide
NetWare Sharing (NCP)
Note: NCP shares can be set up only after Microsoft Services for NetWare (SFN) has been installed
on the NAS 1000s. Procedures for installing SFN are included in Chapter 7, NetWare File System
Management.
From the NetWare Sharing tab, as illustrated in Figure 54, of the Create a New Share dialog
box:
1. Enter a user limit.
2. Enter Permissions information.
The Permissions box lists the currently approved users for this share.
â– To add a new user or group, either select a user or group from the box at the bottom
right of the screen or manually enter the user or group name in the Add a user or
group box. Then click Add. That user or group is added to the Permissions box.
â– To remove access to a currently approved user or group, select the user or group from
the Permissions box, and then click Remove.
â– To indicate the allowed access for each user, select the user and then expand the
Allow and Deny drop down boxes. Then, select the appropriate option.
3. After all NetWare Sharing information is entered, either click the next Sharing tab or click
OK.
Figure 54: Share Properties dialog box, NetWare Sharing tab
To Next Page
Loading...
Need help?
General
