Items Procedures
Troubleshooting steps
Follow suggested steps below one at a time to verify normal boot process:
1. Disconnect all external peripherals, and perform a hard reset (8. Hard reset
on page 113).
2. Perform soft reset (9. Soft reset (Default Settings) on page 115).
3. Update BIOS and drivers (4. Update BIOS and drivers on page 105).
a. Roll back to previous version may be necessary.
b. Go to safe mode to install drivers.
4. Run Hardware Diagnostics (6. HP Hardware Diagnostics and Tools
on page 106) to isolate hardware issue.
5. Undo recent changes in Windows (5. Remove or uninstall recently added
hardware, software on page 105).
6. Reseat cables and connections (10. Reseat cables and connections
on page 115).
7. Start Windows in safe mode (11. Test with minimum conguration
on page 116).
8. Use Startup Repair Windows to x Windows damaged les.
9. Test with essential hardware conguration (11. Test with minimum
conguration on page 116) along with a veried working operating system
(i.e., USB Windows-To-Go ) if available to isolate the software issue.
Tips and tricks For more information, see http://support.hp.com/us-en/document/c03671001.
Electromagnetic Interference (EMI)
Items Procedures
Symptoms
System locks up, freezes in certain
physical area or location
Possible causes
Electromagnetic interference (EMI).
Troubleshooting steps
1. See (2. Examine the environment on page 104). Pay attention to external power source,
high-frequency signals such as cell phones, microwave ovens.
2. Move the computer to dierent locations nearby to determine where it fails and where it
does not fail.
3. Test with a veried working computer in original factory conguration.
134 Chapter 7 Troubleshooting guide
To Next Page
Loading...
Need help?
General
