SERVICE SCHEDULE 10
43
Every 10 operating hours when used for motorsports
Every 45 operating hours
Every 30 operating hours
Every 15 operating hours
After 1 operating hour
Check all hoses (e.g. fuel, cooling, bleeder, drainage hoses, etc.) and sleeves for
cracking, tightness, and correct routing.
○ ● ● ● ●
Check the antifreeze and coolant level. ( p. 121) ○ ● ● ● ●
Check the cables for damage and for routing without kinks. ● ● ● ●
Check that the throttle cables are undamaged, routed without sharp bends, and set
correctly.
○ ● ● ● ●
Clean the air filter and air filter box. ( p. 69) ● ● ● ●
Change the glass fiber yarn filling in the main silencer. ( p. 74) ● ●
Service the fork. ●
Perform the shock absorber service. ●
Check the tightness of the easily accessible, safety-relevant screws and nuts. ○ ● ● ● ●
Check the headlight setting. ( p. 118) ○ ● ● ● ●
Change the fuel screen. ( p. 131) ○ ● ● ● ●
Check the fuel pressure. ● ● ● ●
Check the idle speed. ○ ● ● ● ●
Check that the radiator fan is functioning properly. ○ ● ● ●
Check the inlet membrane. ●
Final check: Check the vehicle is roadworthy and take a test ride. ○ ● ● ● ●
Read out the fault memory after the test ride using the Husqvarna Motorcycles diag-
nostics tool.
○ ● ● ● ●
Make a service entry in Husqvarna Motorcycles Dealer.net. ○ ● ● ● ●
○ One-time interval
● Periodic interval
10.3 Recommended work
every 48 months
every 12 months
Every 135 operating hours
Every 70 operating hours when used for motorsports
After 20 operating hours
After 10 operating hours
Change the front brake fluid. ● ●
Change the rear brake fluid. ● ●
Change the hydraulic clutch fluid. ( p. 87) ● ●
Lubricate the steering head bearing. ( p. 62) ● ●
Clean the spark arrestor. (FE US) ( p. 72) ● ●
Service the fork. ○
Perform the shock absorber service. ○
Change the fuel filter. ●
Change the coolant. ( p. 124) ●
To Next Page
Loading...
Need help?
General
