DynaMAX 550P/560P/575P Waterjet Pump Operator Manual 811390 17
Environmental stewardship
Hypertherm products: waste and recycling
Hypertherm waterjet cutting systems, like all products with electronics, can contain materials or
parts, such as printed circuit boards, that cannot be discarded with ordinary waste. It is your
responsibility to discard Hypertherm products or parts in an environmentally suitable manner and in
compliance with national and local codes.
In the United States, read all national, state, and local laws. In the European Union (EU), read the EU
directives, national, and local laws. In other countries, refer to national and local laws. Consult with
legal or other compliance experts, when applicable. For information, go to
www.hypertherm.com/customer-support/product-service/recycling.
Particle emission and waste water quality
Hypertherm does not manufacture or supply the materials that are cut and has no knowledge about
the particles released from materials that are cut and if they can pose a physical danger or health
risk. Get advice from your supplier or other technical advisor for guidance concerning the properties
of the material you cut with a Hypertherm product.
If you are not familiar with the current applicable government regulations and legal standards for the
installation site, get advice from a local expert before you purchase, install, and operate this
equipment.
To Next Page
Loading...
Need help?
General
