1-2
Introduction
This chapter gives a general overview of the Aptiva Machine Type 2153/2139,
describes the standard and optional features, and details functional and
environmental specifications.
Product Overview
Machine Type 2153/K6 contains one ISA slot and one shared PCI/ISA slot,
and the system board supports the AMD processor. Machine Type
2153/Celeron contains two ISA slot, two PCI slot and one shared PCI/ISA
slot, and the system board supports the Celeron processor Machine Type
2139 contains one ISA slot, two PCI slots and one shared PCI/ISA slot, and
the system board supports the Pentium II processor. Both support
Accelerated Graphics Port (AGP), which allows all installed system memory to
be used as texture memory, yielding a huge texture footprint to enhance 3D
graphical display performance.
Listed below are 2153 and 2139 system features:
Processors (Machine Type 2153/K6)
•
Processor with the capabilities of MMX™ technology
•
Socket-7 Zero Insertion Force (ZIF) connector. You must remove the old
processor to install an upgrade processor.
•
Detachable CPU heat sink with fan.
•
One of the following processors can be installed:
−
AMD K6-2 266 processor; 66 MHz external, 266 MHz internal
−
AMD K6-2 300 processor; 100 MHz external, 300 MHz internal
−
AMD K6-2 333 processor; 95 MHz external, 333 MHz internal
−
AMD K6-2 350 processor; 100 MHz external, 350 MHz internal
Processors (Machine Type 2139, 2153/Celeron)
•
Processor with the capabilities of MMX™ technology
•
Processor in Single Edge Contact (S.E.C.) cartridge packaging technology
•
Dual Independent Bus architecture separates dedicated external system
bus and dedicated internal high-speed cache bus socketability
•
One of the following processors can be installed:
To Next Page
Loading...
Need help?
General
