IBM Power System E950 9040-MR9 User Manual

Figure 33. Replacing the front bezel
Installing the power supplies and cabling the system
When your system comes preinstalled in a rack, you must install the power supplies into the system
chassis and then cable the system. Learn how to install the power supplies.
About this task
To install the power supplies, complete the following steps:
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Move to the rear of the rack.
Note: Follow the packaging instructions to determine the correct placement of each power supply.
3. Align the power supply with the bay and slide the power supply into the system until the latch locks
in place, as shown in the following gure.
Installing the IBM Power System E950 (9040-MR9)
41

IBM Power System E950 9040-MR9 Specifications

General

Brand	IBM
Model	Power System E950 9040-MR9
Category	Server
Language	English