Checkpoint Description Action/
Possible Failing FRU
99FF Service processor writing firmware update
module
See note 2 on page 167.
Attention: This checkpoint may stay in
the operator panel for some period of time
during a firmware update or hypervisor
dump with no indication of activity. Do not
assume that the service processor is hung
unless this checkpoint has been in the
operator panel for at least 15 minutes. with
no indication of activity.
Attention: Do not remove power from the
system, or reset the service processor,
during a firmware update or hypervisor
dump.
A800 Start service processor dump process See note 1 on page 167.
A801 Start dump to NVRAM See note 1 on page 167.
A802 Start dump to debug port See note 1 on page 167.
A803 NVRAM not usable See note 1 on page 167.
A804 NVRAM dump done See note 1 on page 167.
A805 Start dump to flash See note 1 on page 167.
A806 Flash dump area done See note 1 on page 167.
A807 Flash area not usable See note 1 on page 167.
A808 Flash error log to debug port See note 1 on page 167.
A809 Flash erase start See note 1 on page 167.
A80A Flash erase end See note 1 on page 167.
A80B Reserved; not used See note 1 on page 167.
A80C Reserved; not used See note 1 on page 167.
A80D Reserved; not used See note 1 on page 167.
A80E Reserved; not used See note 1 on page 167.
A80F Service processor dump done See note 1 on page 167.
A810-A8FF Description: Scan log dump in progress
Action/Possible Failing FRU Informational message. (See “Scan Log Dump Policy” on
page 370.)
The last two characters of the checkpoints will change as the scan log dump progresses.
If the last two characters do not change after 5 minutes, the service processor is hung
and must be reset. Follow the procedure outlined in Note 1 on page 167 following this
table.
When the scan log dump is complete, depending on how the reboot policy is set, the
system will either:
v Go to the standby state (and the service processor menus will be available), indicated
by OK or STBY in the operator panel,
OR
v Attempt to reboot.
B0F5 Delayed power-off sequence has begun See note 1 on page 167.
166 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide
To Next Page
Loading...
Need help?
General