Back Cover Replacement (Model 6E4)
To replace the back cover, do the following:
1. Ensure all cables have been connected and are correctly seated.
2. Align the back cover side edges with the side edges of the system chassis back.
3. Raise the back cover about 1 inch higher than the system, ensuring tab to slot clearance.
4. Push the back cover straight down. This action seats the tabs into their retaining slots.
Disk Drive Access Cover Removal (Model 6E4)
To remove the disk drive access cover, do the following:
1. Open the bezel door.
2. Locate the disk drive access cover on the front bezel of the system, as shown in the following
illustration.
3. Press down on the release tab located at the top of the access cover.
4. Gently pull the top of the access cover out and away from the system.
Note: The two alignment tabs that are located on the bottom front edge of the access cover must be
lifted up and then out of their slots.
5. Put the cover in a safe place.
1 Model 6E4 4 Disk Drive Access Cover
2 Bezel Door 5 Alignment Tabs
3 Disk Drive Access Cover Release Tab
Disk Drive Access Cover Replacement (Model 6E4)
To replace the disk drive access cover, do the following:
1. Insert the two alignment tabs, located on the bottom front edge of the access cover, into the two slots
located on the front bezel.
2. After inserting the alignment tabs into the slots, pivot the access cover up until the release tab clicks
into the closed position.
3. Close the bezel door.
438 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide
To Next Page
Loading...
Need help?
General