Right Side Cover (System Base) Removal (Model 6E4)
To remove the right side cover (system base), do the following:
1. Remove the bezel door as described in “Bezel Door Removal” on page 441.
2. Remove the front bezel as described in “Front Bezel Removal (Model 6E4)” on page 443.
3. Remove the top cap as described in “Top Cap Removal (Model 6E4)” on page 432.
4. Remove the operator panel as described in “Operator Panel Removal” on page 484.
5. Remove the back cover as described in “Back Cover Removal (Model 6E4)” on page 437.
6. Remove the outer service access cover as described in “Outer Side Cover Removal (Model 6E4)” on
page 435.
7. Remove the top cover as described in “Top Cover Removal (Model 6E4)” on page 433.
8. Remove the four retaining screws that secure the system chassis to the system base.
9. Use three people to lift the system up and off the alignment pins.
10. To remove the system base plate, lay the system onto its side and remove the four retaining screws.
1 Top Cap 8 Bezel
2 Operator Panel EMC Bracket 9 Rear Top Cover Mounting Bracket
3 Operator Panel 10 Rear Cover
4 Operator Panel Bracket 11 System Base Plate
5 Top Cover 12 Operator Panel Extension Cable
6 Model 6E4 13 Right Side Cover (System Base)
7 Bezel Door
Chapter 9. Removal and Replacement Procedures 439
To Next Page
Loading...
Need help?
General