EasyManuals Logo
Home>IBM>Server>pSeries 630 6C4

IBM pSeries 630 6C4 User Manual

IBM pSeries 630 6C4
651 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #505 background imageLoading...
Page #505 background image
Model 6E4 Operator Panel
1 Top Cap 4 Front Bezel
2 Operator Panel 5 Bezel Door
3 Operator Panel Retaining Screws 6 Model 6E4
Operator Panel Replacement
Attention: If you are replacing the operator panel with a new FRU, you must write the system VPD
information (machine type, model number, and serial number) into the VPD module. You must contact the
support center to obtain instructions and the necessary password to enter the information into the VPD
module.
Note: Refer to “System Vital Product Data (VPD) Update Procedure” on page 486 for the correct
procedure.
To replace the operator panel, do the following:
1. Carefully slide the operator panel back into the system bay.
2. Connect the signal and power cable to the connector on the new operator panel.
3. Secure the operator panel with the two retaining screws previously removed.
4. Replace the service access cover, as described in “Service Access Cover Replacement (Model 6C4)”
on page 431.
5. If you are servicing a Model 6C4, push the system drawer back into the operating position as
described in “Returning the Model 6C4 to the Operating Position” on page 430.
6. Reconnect all system power cables.
7. Replace the front bezel as described in “Front Bezel Replacement (Model 6C4)” on page 442 or
“Front Bezel Replacement (Model 6E4)” on page 443.
8. If necessary replace the bezel door as described in “Bezel Door Replacement” on page 441.
9. If you are servicing a Model 6E4, replace the top cap as described in “Top Cap Replacement (Model
6E4)” on page 432.
10. Power on the system as described in “Starting the System without an HMC Attached” on page 425.
11. If the Model 6C4 has successfully powered on, close the rack doors.
If the Model 6E4 has successfully powered on, close the bezel door.
Chapter 9. Removal and Replacement Procedures 485

Table of Contents

Other manuals for IBM pSeries 630 6C4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM pSeries 630 6C4 and is the answer not in the manual?

IBM pSeries 630 6C4 Specifications

General IconGeneral
BrandIBM
ModelpSeries 630 6C4
CategoryServer
LanguageEnglish

Related product manuals