EasyManuals Logo
Home>IBM>Storage>System Storage TS3400 Tape Library

IBM System Storage TS3400 Tape Library User Manual

IBM System Storage TS3400 Tape Library
295 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #186 background imageLoading...
Page #186 background image
8-32 TS3400 Tape Library Maintenance Information
2. Type /opt/IBMtape/tapeutil. (This menu reappears at the completion of each
command.)
3. At the Enter Selection: prompt, select to open the device.
4. At the Enter device special file name: prompt, type /dev/rmt/1st (or the actual
device special file for your device).
5. At the Select mode (1=read-write, 2=read, 3=write, 4=append): prompt, type 1.
The Device opened response is displayed.
6. At the Enter Selection: prompt, select the Inquiry option to receive the device
inquiry data.
7. At the Enter Selection: prompt, select the Test Unit Ready option to verify
device test-unit ready.
8. At the Enter Selection: prompt, select the Read/Write Tests option to perform
write verification.
9. At the Enter Block Size: prompt, type 1024.
10. At the Number of Blocks: prompt, type 20.
11. At the Number of Repetitions: prompt, type 10.
12. At the Enter Selection: prompt, select the Rewind option to rewind the tape.
13. At the Enter Selection: prompt, select 2 to close the device. The Device Closed
response is displayed.
14. At the Enter Selection: prompt, select Q to exit the tapetest program.
Checking Channel Attachment – HP-UX
The devices must be fully installed and the host device driver must be configured and
available. See IBM SCSI Tape Drive, Medium Changer, and Library Device Drivers:
Installation and Users Guide for information about installing and using the IBM SCSI
library device drivers. Also, “Installation and Configuration Instructions” in the
above guide describes the smit and cfgmgr commands.
Figure 8-6 shows an example of the software and hardware paths that are used in the
following tests. The figure illustrates the unique initiator addresses for a
configuration with more than one initiator sharing a SCSI bus.
Figure 8-6. Host Attachment Example
TAPEUTIL TAPEUTIL
Tape Special File Tape Special File
Tape Device
Driver
Tape Device
Driver
Adapter Device
Driver
(ID 7)
Adapter Device
Driver
(ID 6)
To Host
Port 0 Port 1
3592 Tape Drive
a14m0019

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM System Storage TS3400 Tape Library and is the answer not in the manual?

IBM System Storage TS3400 Tape Library Specifications

General IconGeneral
BrandIBM
ModelSystem Storage TS3400 Tape Library
CategoryStorage
LanguageEnglish

Related product manuals