IBM System Storage TS3400 Tape Library User Manual

Chapter 1. Start Service 1-15
Drive Error Codes
00F8
Sensor error #7.
During blink check, a Y
encoder sensor error was
detected.
CHK 00F8
1. Cycle the power and try again.
2. Replace the Library Control Blade (page 9-8).
3. Replace the Accessor assembly (page 9-23).
4. Replace the Accessor Flat Cable Plate assembly (page 9-28).
5. Replace the Back Board assembly (page 9-37).
6. Replace the TS3400 Tape Library chassis (page 9-44).
00F9
Sensor error #8.
During blink check, an X
encoder sensor error was
detected.
CHK 00F9
00FA
Sensor error #9.
During blink check, an
I/O slot sensor error was
detected.
CHK 00FA
00FB
Sensor error #10.
During blink check, a
magazine (Upper) sensor
error was detected.
CHK 00FB
00FC
Sensor error #11.
During blink check, a
magazine (Lower) sensor
error was detected.
CHK 00FC
00FD
Sensor error #12.
During blink check, an X
origin sensor error was
detected.
CHK 00FD
Table 1-2. Drive error codes
Code (H) Description
Panel
indication
Action Required
0200
Invalid data was sent to
Drive #1.
NAK was detected.
CHK 0200
1. Confirm the drive connection.
2. Cycle the power and try again.
3. Replace the Library Control Blade (page 9-8).
4. Replace the drive canister (page 9-11).
5. Replace the Drive Docking Card (page 9-19).
6. Replace the Back Board assembly (page 9-37).
7. Replace the TS3400 Tape Library chassis (page 9-44).
0201
A timeout error occurred
while waiting for response
from Drive #1.
CHK 0201
0203 Drive #1 is disconnected. CHK 0203
0205 Drive #1 is busy. CHK 0205
0206
Drive #1 failed to execute
a command because drive
could not be mounted.
CHK 0206
Table 1-1. Library error codes (continued)
Code (H) Description
Panel
Indication
Action Required

IBM System Storage TS3400 Tape Library Specifications

General

Brand	IBM
Model	System Storage TS3400 Tape Library
Category	Storage
Language	English