9-3
■ Voice squelch control function
This function is useful when you don’t want unmodu-
lated signals pausing or cancelling a scan. When the
voice squelch control function is activated, the receiver
checks received signals for voice components.
If a receiver signal includes voice components, and
the tone of the voice components changes within 1
second, scan pauses (or stops). If the received sig-
nal includes no voice components or the tone of the
voice components does not change within 1 second,
scan resumes.
➥ While a phone mode (SSB, AM or FM) is selected,
push[VSC]toswitchtheVSC(VoiceSquelchCon-
trol) function ON or OFF.
•“VSC”appearswhenthefunctionisactivated.
•TheVSCfunctionactivatesforanyscan.
•TheVSCfunctionresumesthescanonunmodu-
lated signals, regardless of whether the scan re-
sume condition is set to ON or OFF.
■ Scan set mode
[F-2•Z][F-1•Y]
[EXIT/SET] Main dial[F-4•DEF]
When the squelch is open, scan continues until it is
stopped manually— it does not pause on detected sig-
nals. When squelch is closed, scan stops when de-
tecting a signal, then resumes according to the scan
resume condition. Scan speed and the scan resume
condition can be set using the scan set mode.
qPush[F-5•SCAN]toselectscanscreen.
wPush[F-7•SET]toselectscansetmode.
ePush[F-1•Y]or[F-2•Z] to select the desired item.
r Rotate the main dial to select the desired condition.
•Holddown[F-4•DEF]for1secondtoselectthedefault
setting.
t Push [EXIT/SET] to return to scan menu.
9
SCANS
Select the desired scan speed from high and low. •HIGH :scanisfaster
•LOW :scanisslower
Set the scan resume function ON or OFF. •ON :Whendetectingasignal,scanpausesfor10
seconds, then resumes. When a signal disap-
pears, scan resumes 2 seconds later.
•OFF:Whendetectingasignal,cancelsscanning.
To Next Page
Loading...
Need help?
General
