Icom IC-7800 User Manual

4-11
D Keyer set mode
This set mode is used to set the memory keyer re-
peat time, dash weight, paddle specifications, keyer
type, etc.
• Setting contents
[F-1•Y] Main dial[EXIT/SET][F-2•Z][F-4•DEF]
qDuringCWmodeoperation,push[F-3•KEYER]to
select memory keyer screen.
wPush[EXIT•SET]toselectmemory keyermenu,
thenpush[F-4•CWKEY]toselectkeyersetmode.
ePush[F-1•Y ]or[F-2•Z] to select the desired set
item.
r Set the desired condition using the main dial.
 •Holddown[F-4•DEF]for1secondtoselectthedefault
condition or value.
• Keyer set mode screen t Push [EXIT/SET] twice to normal screen.
4
RECEIVE AND TRANSMIT
to be continued…
This item sets the dot/dash ratio.
Keying weight example: Morse code “K”
DASH
Weight setting:
1:1:3 (default)
Weight setting:
Adjusted
DASH
DOT (fixed*)
Adjustable range SPACE (fixed*)
*SPACE and DOT length can be
adjusted with [KEY SPEED] only.
•1:1:2.8to1:1:4.5(in0.1steps)canbeselected.
(default: 1:1:3.0)
This item sets the rise time of the transmitted CW en-
velope.
Key action
Tx output power
• About rise time
Rise time
Tx
Rx
Set Tx power level
Time
0
• 2, 4, 6 or 8 milliseconds can be selected.
(default: 4 milliseconds)
When sending CW using the repeat timer, this item
sets the time between transmission.
•1to60secondsin1secondstepscanbeselected.
(default: 2 seconds)

Icom IC-7800 Specifications

General

Brand	Icom
Model	IC-7800
Category	Transceiver
Language	English