117
12
OTHER FUNCTIONS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
■ Cloning function
The IC-91A/91AD has transceiver-to-transceiver data cloning
capability. This function is useful when you want to copy all
of the programmed contents from one IC-91A/91AD to an-
other.
• An optional OPC-474
CLONING CABLE is required.
q Turn the transceiver’s power OFF, then connect an op-
tional OPC-474 between both [SP] jacks.
w While pushing [MR] and [MENU/LOCK], push and hold
[PWR] for 1 sec. to enter cloning mode.
•“CLONE M” appears.
e Push [PTT] on the “master” transceiver.
•“CLONE OUT M” appears and the bar meter shows that cloning
is taking place.
• After the cloning is completed, the display returns to “CLONE M.”
r Push and hold [PWR] for 1 sec. to turn power OFF.
The optional RS-91
REMOTE CONTROL SOFTWARE is also
available to clone/edit contents with a PC (for Microsoft
®
Win-
dows
®
98/98SE/ME/2000XP) and using ICF format files.
Microsoft
®
and Windows
®
are registered trademarks of Microsoft Corporation in
the U.S.A. and other countries.
■ [MIC/SP] jacks
To connect external equipment such as speaker, microphone,
TNC, etc. refer to the diagram below.
The center terminal of [MIC] outputs 3.3 V DC via 330 Ω
resistor.
To Next Page
Loading...
Need help?
General
