Icom IC-91A User Manual

■ Scan resume condition
DD
Scan pause timer
The scan pauses when receiving signals according to the
scan pause time. It can be set from 2 to 20 sec. or unlimited.
qEnter “PAUSE” in scan set mode.
(p. 96)
w Rotate [DIAL]
†
to set the desired scan pausing time from
2–20 sec. (2 sec. steps) or “HOLD.”
•“2SEC”–“20SEC”: Scan pauses for 2–20 sec. while receiving a
signal.
•“HOLD” : Scan pauses on a received a signal until it
disappears.
e Push [ï](5) (or [
ΩΩ
](4)) to return to scan set mode.
r [MENU/LOCK] to return to frequency indication.
DD
Scan resume timer
The scan restarts after the signal disappears according to the
resume time. It can be set from 0–5 sec. or unlimited.
qEnter “RESUME” in scan set mode.
(p. 96)
w Rotate [DIAL]
†
to set the desired scan resume time from
0–5 sec. (1 sec. steps) and “HOLD.”
•“0SEC” : Scan restarts immediately after the signal
disappears.
•“1SEC”–“5SEC” : Scan restarts 1–5 sec. after the signal disap-
pears.
•“HOLD” : Scan restarts by rotating [DIAL] only.
e Push [ï](5) (or [
ΩΩ
](4)) to return to scan set mode.
r [MENU/LOCK] to return to frequency indication.
Scan resume timer must be set shorter than the scan
pause timer, otherwise this timer does not activate.
• Resume timer setting
2SEC2SEC
4SEC4SEC
3SEC3SEC
1SEC1SEC
5SEC5SEC
RESUME TIMER
r
MENU screen ➪ SCAN ➪ RESUME
(Push [MENU/LOCK]) (Rotate [DIAL]
†
, then push [ï](5)
†
.)
10SEC10SEC
6SEC6SEC
8SEC8SEC
4SEC4SEC
12SEC12SEC
PAUSE TIMER
r
• Pause timer setting
MENU screen ➪ SCAN ➪ PAUSE
(Push [MENU/LOCK]) (Rotate [DIAL]
†
, then push [ï](5)
†
.)
81
9
SCAN OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
†
[DIAL] ↔ [
∫∫
](2)/[
√√
](8) [ï](5) ↔ [
≈≈
](6)

Icom IC-91A Specifications

General

Brand	Icom
Model	IC-91A
Category	Transceiver
Language	English